Contact Us

TEL : +86-379-63059698
E-mail: slewdrive@ldb-bearing.com
Address: Yiyang Bearing Industry Zone, Luoyang, Henan, China

                
Home > News > Content
Rotate The Correct Way To Use The Drive
May 22, 2017

There are a lot of people in the installation of the rotary drive when there is a mistake, the wrong way to use the rotation drive has led to no way to play its role or lead to equipment is no way to use, then the correct use of rotary drive in the end what is it?


We can use the hydraulic press when we install the rotary drive in large quantities. In the press of the time, need to ensure that the outer ring end face and the shell shoulder face, inner ring end and shaft shoulder face compression, does not allow a gap. When the larger amount of interference can be used when the oil bath heating or sensor heating rotary drive method to install, heating temperature range of 80 ℃ to 100 ℃ or so, the maximum can not exceed 120 ℃. At the same time, the application of nuts or other appropriate methods to tighten the rotary drive to prevent the rotation drive cooling after the width of the direction of contraction between the collar and the shoulder to produce a gap between the single-row tapered roller rotation drive installation of the final need to adjust the clearance The The clearance value needs to be determined according to the different working conditions and the amount of interference required. When necessary, we need to test to determine. Double row tapered roller rotation drive and pump shaft rotation drive at the time of the factory has been adjusted for the clearance, the installation does not have to continue to adjust.